Mitsubishi Electronics R100 Manual de usuario descargar pdf (Pagina 18)

Chapter 2 - Installation

2. Installation

18 R100 Wireless Gateway

Connecting to the R100 Wireless Gateway

Wired Connection

One RJ-45 cable is supplied with the R100 Wireless Gateway. Auto

crossover functionality is built-in to the gateway, so you can use

either a straight-through or a crossover ethernet cable. Plug one end

of the cable into the WAN port on the rear of the wireless gateway and

the other end into the ethernet port of your ADSL or Cable modem.

Wireless-Connection

Refer to your wireless adapter’s user manual on associating with the

R100. The default SSID of the gateway is “default” (lower case),

encryption is disabled and open system authentication is used.

Printer Connection

A DB-25 parallel cable should be supplied with your printer. Plug the

male connector of this cable into the printer port on the rear of the

R100 and the centronics end into your printer.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 101 102

Sin comentarios

Mitsubishi Electronics R100 Manual de usuario Pagina 18