Mitsubishi Electronics MR-J2M-P8B Manual de usuario descargar pdf (Pagina 163)

12 - 14

12. OPTIONS AND AUXILIARY EQUIPMENT

When fabricating an encoder cable, use the recommended wires given in Section 12.2.1 and the

MR-J2CNM connector set for encoder cable fabrication, and fabricate an encoder cable as shown

in the following wiring diagram. Referring to this wiring diagram, you can fabricate an encoder

cable of up to 50m (164.0ft) length.

When the encoder cable is to be fabricated by the customer, the wiring of MD and MDR is not

required.

Refer to Chapter 3 of the servo motor instruction manual and choose the encode side connector

according to the servo motor installation environment.

Drive unit side

(3M)

MRR

BAT

MDR

Note. Always make connection for use in an absolute position detection system.

This wiring is not needed for use in an incremental system.

Encoder side

Plate

(Note)

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 194 195

Sin comentarios

Mitsubishi Electronics MR-J2M-P8B Manual de usuario Pagina 163